-rw-r--r-- 4619 LICENSE.txt
-rw-r--r-- 779 Makefile
-rw-r--r-- 2800 README.md
-rw-r--r-- 14829 icmpmonitor.c
-rw-r--r-- 1043 icmpmonitor.ini
drwxr-xr-x - iniparser


ICMPmonitor pings a set of hosts, executing per-host, user-defined commands whenever a host begins or ceases to respond.

Assuming your build environment is suitable, build and execute the example configuration with the following commands.

% make clean && make
% sudo ./icmpmonitor -f ./icmpmonitor.ini -v


Complete. Tested on OpenBSD, FreeBSD and Debian Linux.


After editing the Makefile to suit your environment, build ICMPmonitor with make clean && make. Copy the resulting icmpmonitor binary somewhere suitable and create a configuration file based on the examples in icmpmonitor.ini.

Execute ICMPmonitor as shown below, adding any additional flags desired. Note that ICMPmonitor requires permission to send and receive network packets.

% sudo icmpmonitor -f /path/to/config/file.ini

Reference: Command Line Flags

-f <file>  Required. Pathname of configuration file.

-v         Enable verbose mode, printing a message for each packet
           sent/received as well as each host up/down event.

-r         Repeat `down_cmd` every time a downed host fails to respond to
           a ping. This contrasts with the default behavior which executes
           `down_cmd` only once per downed host event, requiring a ping
           response to complete the event before `down_cmd` can repeat.

-h         Prints simple help information and exits.

Reference: Configuration File Format

Each host to be monitored should have a corresponding host entry in the configuration file. This entry consists of a label in square brackets and a series of mandatory configuration options. Comments may be included and are demarked with pound signs. For example:

[Example entry for localhost]
host =
interval = 2
max_delay = 30
up_cmd = "echo host up"  # This is a comment.
down_cmd = "echo host down"
start_condition = down

The host option references the host to be monitored and can be either an IP address or fully-qualified hostname.

The interval specifies the number of seconds between pings. Values smaller than TIMER_RESOLUTION as #defineded in icmpmonitor.c will result in a ping sent roughly once every TIMER_RESOLUTION seconds.

Hosts will only be marked down after missing all pings sent in the last max_delay seconds.

After a host misses all pings sent in the last max_delay seconds, the down_cmd is executed. Upon receipt of a response from the host, the up_cmd is executed and all counters are reset.

The initial state ICMPmonitor should assume is specified by start_condition. This can be important if the external commands executed for up/down events have significant consequences. Allowed values are up or down.