fs.h --> ufs from sys

[unix-history] / usr / src / usr.sbin / bad144 / bad144.8

diff --git a/usr/src/usr.sbin/bad144/bad144.8 b/usr/src/usr.sbin/bad144/bad144.8
index 265fdd9..def660e 100644 (file)
--- a/usr/src/usr.sbin/bad144/bad144.8
+++ b/usr/src/usr.sbin/bad144/bad144.8
@@ -1,8 +1,8 @@
-.\" Copyright (c) 1980 Regents of the University of California.
+.\" Copyright (c) 1980, 1988 Regents of the University of California.

 .\" All rights reserved.  The Berkeley software License Agreement
 .\" specifies the terms and conditions for redistribution.
 .\"
 .\" All rights reserved.  The Berkeley software License Agreement
 .\" specifies the terms and conditions for redistribution.
 .\"

-.\"    @(#)bad144.8    6.4 (Berkeley) %G%
+.\"    @(#)bad144.8    6.5 (Berkeley) %G%

 .\"
 .TH BAD144 8 ""
 .UC 4
 .\"
 .TH BAD144 8 ""
 .UC 4


@@ -98,7 +98,6 @@ Note, however, that
 does not arrange for the specified sectors to be marked bad in this case.
 This procedure should only be used to restore known bad sector information which
 was destroyed.
 does not arrange for the specified sectors to be marked bad in this case.
 This procedure should only be used to restore known bad sector information which
 was destroyed.

-It is necessary to reboot before any change will take effect.

 .PP
 With the
 .B \-a
 .PP
 With the
 .B \-a


@@ -122,25 +121,13 @@ or SMD disk on a Massbus, the
 .B \-f
 option may be used to mark the new bad sectors as ``bad''
 by reformatting them as unusable sectors.
 .B \-f
 option may be used to mark the new bad sectors as ``bad''
 by reformatting them as unusable sectors.

-\fBNOTE:  this can be done safely only when there is no other disk activity\fP,
-preferably while running single-user.

 This option is required unless the sectors have already been marked bad,
 or the system will not be notified that it should use the replacement sector.
 This option is required unless the sectors have already been marked bad,
 or the system will not be notified that it should use the replacement sector.

+This option may be used while running multiuser; it is no longer necessary
+to perform format operations while running single-user.

 .PP
 .PP

-The normal procedure for adding new bad sectors to an SMD or RP06 drive
-with an existing bad sector table is the following:
-.IP 1.
-Shut down to single-user operation.
-.IP 2.
-Use ``\c
-.I bad144 \-a \-f
-drive sector ...''
-to add new bad sectors to the table, formatting them as bad.
-The
-.B \-c
-option may also be used if the original sectors may be readable.
-.IP 3.
-Reboot to allow the kernel to reread the bad-sector table from the drive.
+It is no longer necessary to reboot to allow the kernel
+to reread the bad-sector table from the drive.

 .SH SEE ALSO
 badsect(8),
 format(8V)
 .SH SEE ALSO
 badsect(8),
 format(8V)