.\" Copyright (c) 1983 Regents of the University of California.
.\" All rights reserved. The Berkeley software License Agreement
.\" specifies the terms and conditions for redistribution.
.\" @(#)acc.4 6.1 (Berkeley) %G%
acc \- ACC LH/DH IMP interface
.B "device acc0 at uba0 csr 167600 vector accrint accxint"
device provides a Local Host/Distant Host
interface to an IMP. It is normally used when participating
in the DARPA Internet. The controller itself is not accessible
to users, but instead provides the hardware support to the IMP
pseudo-device must also be included.
The initialization routine was entered even though the device
did not autoconfigure. This indicates a system problem.
.BR "acc%d: can't initialize" .
Insufficient UNIBUS resources existed to initialize the device.
This is likely to occur when the device is run on a buffered
data path on an 11/750 and other network interfaces are also
configured to use buffered data paths, or when it is configured
to use buffered data paths on an 11/730 (which has none).
.BR "acc%d: imp doesn't respond, icsr=%b" .
The driver attempted to initialize the device, but the IMP
failed to respond after 500 tries. Check the cabling.
.BR "acc%d: stray xmit interrupt, csr=%b" .
An interrupt occurred when no output had previously been started.
.BR "acc%d: output error, ocsr=%b, icsr=%b" .
The device indicated a problem sending data on output.
.BR "acc%d: input error, csr=%b" .
The device indicated a problem receiving data on input.
.BR "acc%d: bad length=%d" .
An input operation resulted in a data transfer of less than
0 or more than 1008 bytes of
data into memory (according to the word count register).
This should never happen as the maximum size of a host-IMP