.\" Copyright (c) 1990 Regents of the University of California.
.\" All rights reserved. The Berkeley software License Agreement
.\" specifies the terms and conditions for redistribution.
.\" @(#)autoconf.4 5.1 (Berkeley) %G%
autoconf \- diagnostics from the autoconfiguration code
When UNIX bootstraps it probes the innards of the machine
and locates controllers, drives, and other devices, printing out
what it finds on the console. This procedure is driven by a system
configuration table which is processed by
and compiled into each kernel.
Autoconfiguration on the HP300s is similar to that on the VAX,
the primary difference is in the naming conventions.
if devices exist which are not configured they will be ignored;
if devices exist of unsupported type they will be ignored.
Normally, the system uses the disk from which it was loaded as the root
a generic system will use ``rd0'' if it exists.
If such a system is booted with the RB_ASKNAME option (see
then the name of the root device is read from the console terminal at boot
time, and any available device may be used.
intro(4), boot(8), config(8)
\fI4.3BSD for the HP300\fR in the distribution documentation package.
\fBCPU type not configured\fR
You tried to boot UNIX on a cpu type which it doesn't
(or at least this compiled version of UNIX doesn't) understand.
\fBhpib%d at sc%d, ipl %d\fR
An HP-IB was found at sc%d (the select code)
with ipl%d (interrupt priority level).
UNIX will call it hpib%d.
\fB%s%d at hpib%d, slave %d\fR
An HP-IB disk or tape controller was found.
For disks %s%d will look like ``rd0'',
The %s in the first line will be a product type like ``7945A'' or ``9144''.
The slave number comes from the address select switches on the drive.
A bit mapped display was found either at the ``internal'' address (first case)
or at some ``external'' select code (second case).
If it exists, the internal display will always be unit 0.
\fB%s%d at sc%d, ipl %d flags %d\fR
Another peripheral controller was found at the indicated select code
and with indicated interrupt priority level.
``dca'' (single-port serial interfaces),
``dcm'' (four-port serial interfaces), or
The slave number comes from the address select switches on the interface card.